Audi Q5 Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
195 Posts
Discussion Starter · #1 ·
Hello!

I have this error in my Q5:

Address 6D: Trunk Elect. (J605) Labels: Redir Fail!
Part No SW: 8R0 827 851 A HW: 8R0 827 851
Component: J605 Master H24 0240
Revision: -------- Serial number: 8R0827851
VCID: 3A7F36DB0E9F

Subsystem 1 - Part No SW: 8R0 827 852 A HW: 8R0 827 852
Component: J756 Slave H24 0240

1 Fault Found:
16347 - Control Module - EEPROM Error
014 - Defective
Freeze Frame:
Fault Status: 01101110
Fault Priority: 1
Fault Frequency: 1
Reset counter: 12
Mileage: 76982 km
Time Indication: 0
Date: 2012.08.18
Time: 15:52:37

I have checked the ross-tech wiki and got this:

16347 - Control Module - EEPROM Error

Possible Symptoms
  • Control Module doesn't perform to factory design
Possible Causes
  • Wrong Firmware Installed
  • Failed Control Module
Possible Solutions
  • Update Firmware of Control Moudle
  • Replaced Control Module
Special Notes
  • When found on:
    • VW ABS modules, see TPI 2017922
    • Bosch 8.0 ABS module, see TPI 2008907
    • Skoda with Bosch 8.0 ABS modules, see TPI 2014687
    • Audi A3 or TT Steering Assist, see TPI 2021189
    • Audi A8 Electronic Parking Brake, see TPI 2016072

My electric trunk still work fine... I have check the dealer and there's not any recall to my VIN.

Anyone have anything similar?
 

·
Registered
Joined
·
1 Posts
I have this error too. My trunk will not save the height adjustment even though my lights blink after holding the close button in for 3 seconds. I suspect its related to this error code. Can you set your trunk height successfully?
 
1 - 3 of 3 Posts
Top